SCSI SCA Converter Technical Summary (without termination)
This device converts SCA 80 pin to 68 pin (SCSI-3) and 50 pin headers (SCSI-1 & SCSI-2). It is typically used to connect the latest SCSI devices, such as hard drives,
which are equipped with a SCA connector to a SCSI controller card or cabling.
Dimensions: Length 91.50 mm, Width 39.40 mm, Thickness 21.45 mm (all +/- 0.25mm)
Jumper Settings Descriptions (1-4)
| 1. |
LED |
Front panel LED signal, indicates drive activity. |
| 2. |
SYN |
Synchronous spindle synchronizing signal generated by host or drive |
| 3. |
DLY |
Asserted by host to enable Delayed Motor Start Option (motor starts
at power on or after a delay of 12 seconds times drive ID). This and MTR are mutually exclusive options.
|
| 4. |
MTR |
Asserted by host to enable Motor Start Option (enables starting
motor via SCSI bus command).
|
SCSI ID Settings Chart (5-8)
It is possible to set the SCSI ID for the convertor from ID #0 to #15. This is
should match that of your SCSI device if the device has ability to select its
own SCSI id. This is achieved by jumper settings on pins 5, 6, 7 and 8, as shown below.
|
